| I managed to get the drive shaft nuts undone by
attaching a long length of angle iron to the back plate and using a tubular extension on
the wrench. |
 |
| To get a look at the inside of the chassis I cut
back some of the top sheet. The two rows of holes take the seat mounting and there are two
catches further back. There is a reinforcing plate behind them. |
 |
| I put the camera in the chassis and this is what
it saw on the left side looking back. Not too bad. |
 |
| The inner chassis member looks ok, too. |
 |
| And on the right side looking back. You can see
where the inner member curves back out. |
 |
| The outer member. |
 |
|
|
