| Cleaned up the cylinder heads. |
 |
| Reground the valves. |
 |
| Put on new "goggle"
seals. (Pushrod tube seals.) |
 |
| Knocked off the fins of an old
barrel and used it to lap the cylinder heads to ensure that the seating
area is flat. |
 |
| Replaced the valve springs and
rockers but left the screws loose as two of the cylinder head studs
go through the rocker shafts and they must be tightened first. |
 |
| Put new piston on con rod. |
 |
| Made piston ring compressor
with sheet of steel and the |
 |
| Slide barrel over piston. |
 |
| Removed compressor and pushed
barrel home. |
 |
| Fitted cylinder heads but only
tightened studs to initial torque. The inlet/exhaust manifold has to
be fitted before the studs are fully tightened. |
 |
